![]() ![]() I make sure the board is firmly pressed down against the wasteboard (1/4"x1"å" poplar from Home Depot) Tape has to be along the bottom edge to make sure the corner clamp includes tape thickness. I use double-sided tape every 1.5 inches or so going the full width of the board, making sure if there is a crown in the pcb stock that it is bowed down in the middle. I check the edges for burrs and smooth with a file if necessary since otherwise it throws off the height setting on the corner clamp. Iām using single sided FR1 6å" material from Inventables.It is all SMT except for connectors, switch and LED. ![]() ![]() It has 2- 14pin SOIC, about 20- 1206 size resistors and caps and a few SOTs. Below is an image of a SMT PCB I am about to cut. Have made a couple boards with one SOIC on them.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |